Snow Performance Stage 3 Water & Methanol Injection Kit for the Ford Focus RS / ST
CARB Policy
California regulates aftermarket parts that have the potential to impact emissions. In most cases, the sale and use of emissions-related aftermarket parts on vehicles used on California public roads is prohibited unless it is either a "replacement part" as defined by California, or is a specifically authorized use of that part as reflected in an Executive Order ("EO Part.").
The California Air Resources Board (ARB) regulates aftermarket parts and has promulgated regulations that essentially place all emissions-related aftermarket parts into three categories:
(1) Replacement Parts
Replacement Parts are aftermarket parts that ARB considers to be functionally equivalent to the stock part they are intended to replace, and therefore would not impact the emissions from these vehicles. These parts are appropriate for sale and use on vehicles used on or off the public highways. For aftermarket exhaust systems and parts, there are two applicable scenarios:
(a) If the vehicle's stock exhaust system does not contain a catalytic converter, then an aftermarket exhaust part is a replacement part as long as the part does not remove or replace any emission control equipment originally attached to the stock exhaust system, such as oxygen sensors.
(b) If the vehicle's stock exhaust system contains a catalytic converter in the manifold section of the stock exhaust system, then an aftermarket muffler positioned downstream from the catalytic converter (i.e. cat-back) is a replacement part as long as the part does not remove or replace any emission control equipment originally attached to the stock exhaust system.
(2) Executive Order Parts
Executive Order Parts are aftermarket parts that ARB has evaluated and determined do not adversely impact emissions, and thereby are granted an Executive Order (EO), which allows the part to be sold and used on specified vehicles. Any aftermarket exhaust system that replaces or otherwise impacts emission control equipment, including catalytic converters, requires an EO to be sold and used on a vehicle used on or off a public highway.
(3) Competition Use Only Parts
Competition Use Only Parts may not be sold or used on a vehicle that is used on or off the public highways other than those vehicles used exclusively for competition. Competition Use Only Parts are aftermarket parts that replace or otherwise interfere with the operation of an emission control device, such as a catalytic converter or oxygen sensor, and may be sold and used on a vehicle that is used only for closed course competition.
Specifications
Specifications
|
Make |
Ford |
|---|---|
|
Model |
Focus |
|
Year |
|
|
Trim |
|
| CA Compliance ⚠️ | Not street legal in California. |
| Prop 65 ⚠️ | This product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. |
Ford Focus RS / ST Water & Methanol Injection kit by Snow Performance
Reduce your Ford Focus RS / ST engine inlet air temperatures and suppress harmful detonation with Snow Performance's new Water & Meth Injection Kit. This kit allows you to safely increase boost and advance ignition timing by reliably increasing the octane of your fuel with out the need of high-octane race fuels.
The Snow Performance water & meth injection kit is the most advanced water-methanol direct injection system for your ecoboost motor. The stage 3 creates a 2D injection map based off of boost and fuel pressure sensor voltages to deliver the most accurate and tunable water-meth delivery system on the market.
The Snow Performance Injection kit works by controlling nozzles independently from one another giving you the exact water-methanol through out the rpm range. This gives you the most accurate 2D injection curve resulting in a tunable system that easily gives gains of 50-110 horsepower and reduces air temperatures by 150 degrees.
Snow Performance Ford Focus RS / ST Water-Methanol Injection Kit Includes:300 PSI ultra high output pump3 Qt reservoir All necessary tubing for a quick installation10' 1/4 inch high temp nylon tubing18" high pressure boost line Terminated digital variable mapping controller Terminated Plug&Play wire harness Power solenoid upgrade Level switch upgrade2 nozzle holder/check valve combo3 hyper-sonic nozzles Snow performance decal Required hardware needed for installation Comprehensive instructions to install on direct injected/ecoboost vehicle
